Dubstepforum.com

Does anyone know how to create a mono vst channel in Cubase? I'm looking at the manual now and can't find anything on it, anyone know what page it is on?

At the moment I'm having to create a mono group channel, then route the stereo vst channel into the mono group - is there another way?

I'm using Z3ta on the channel and running Cubase 5..

Just use the stereo tool on the inserts of a stereo channel and click the mono button.

Pedro Sánchez wrote:Just use the stereo tool on the inserts of a stereo channel and click the mono button.

Nice, Thank You

Don't know if this works in Cubase but in logic if im feeling lazy i slap a channel Eq on the channel strip and after, insert the vst/au which stays mono because the effect(eq) is in mono (default channel is mono in logic), where normally it wouldn't let you insert the stereo instrument.

Anyone know if this would have a negative effect?

yea the stereo tool, or when you add need channel say audio click on stereo and switch it to mono

As i tend to group mor than one bass, i just send to a mono group, by far the easiest way imo.

Also, theres this nifty plugin which can mono-ise stuff, gradually, with a fader from full stereo to complete mono.

Useful for the masterbus to check overall mix mono compatibility. Theres a way of doing this in control room too but never use that myself.

http://www.kvraudio.com/get/665.html

ben you can just use the native mono to stereo tool under spatial tools now
just toss it on the channel and click the mono button

oh right i never looked at the standard cubase guff, think i disabled them all /

Will have to check it out.

I liked the blob that changes shape when you use that monomaker tho

deadly habit wrote:yea the stereo tool, or when you add need channel say audio click on stereo and switch it to mono

WAR TORN wrote:

deadly habit wrote:yea the stereo tool, or when you add need channel say audio click on stereo and switch it to mono

Thats for an 'instrument' channel, deadly was talking about 'audio' channels