Dubstepforum.com

Hi everyone, I've searched for an answer to this and came up empty handed. Does anyone know hoe to automate the lfo sync of albino 3 in ableton live 8. I'm trying to draw in the automation. Iv'e used the configure method to get an automation lane with lfo 1 sync in it but when I do draw in the automation, it does nothing. Does anyone know how to do this?

Thanks

Automation of external VSTs should be covered in the Ableton manual - have you tried looking there?

Looked it over again and it says nothing. It shows how to automate them which I already know how. My problem is that the automation isnt doing anything. For example, I'll set the LFO sync 1 to start at 1/8 then go to 1/16 at a certain point, but when I play the clip it doesn't execute the change and stays at 1/8 the whole time. I tried doing this in FL studio and it worked nicely. Also tried it with Massive in Ableton and it also worked. Don't know why Ableton doesn't like Albino. Anyone else using Albino 3 in Ableton? Don't know why everyone badmouths FL studio because as it stands now, it's looking twenty times better than Ableton. Think I'll switch over if I can't find a simple solution.

prelich wrote:but when I do draw in the automation, it does nothing.

Is the 'Back to Arrangement' button at the top of the screen on Red? If so, it might be that ... when it's on red, it stops recent automation changes from working ... click on it to murk it off