How to this synth ?

[horhos]

Hi everyone, I want to know how to do this synth, vst with what can be done? And on what basis certain settings.

http://soundcloud.com/kruegerbass/kastl ... eger-remix

[Manic Harmonic]

You're talking about the lead that starts out at the very beginning right? I'd just use any synth that has an arpeggiator and set it to a saw wave with a really short attack, play some chords, and set the arpeggiator so it cuts the notes really short. There's a lot more going on in that synth, but that would be a good starting point. what daw are you using/ do you have any vst's? You're going to need something with an arpeggiator to do that.

[horhos]

Sorry , i want this synth as 1min10

[Manic Harmonic]

alright well i didn't try too hard and I'm not that great with coming up with patches by ear, but the majoirty of softsynths out there should be able to do this... I just used 2 square wave oscillators detuned against each other with the high end rolled off, with a modulated low pass filter on it (just a little bit), and then some white noise. i put some reverb on it and it sounds pretty close. The pitch changing effect that sounds like someone touching a reel-to-reel tape deck could just be done with the pitch wheel on any midi controller. If you tell me what software/plugins you're using I might be able to help a little bit more.

by the way, he's also using some jazz chords for that pad, which is a big part of the effect.

[horhos]

I use massive , or nexus or polysix !

[Manic Harmonic]

I use massive , or nexus or polysix !

Ok, I did it in massive, ill upload a screenshot when I get a chance, that should give you somewhere to start.

[Aufnahmewindwuschel]

i only know the synth at the beginning haha
i think its a fm 8 preset or something

[horhos]

Thanks for reply , i wait your screenshot .