Dubstepforum.com

No troll srs!

Just wondered if anyone had this with the rokit rp5s? If its a common thing then I won't send them back. Using a cable with an xlr adapter thing on the end. Not sure what type of cables they are tbh, someone just gave me them. I'l post a screenie.

Anyone?

this may sound silly but it's gotta be asked, are the individual speakers volumes at the same level?

Huts wrote:this may sound silly but it's gotta be asked, are the individual speakers volumes at the same level?

Yeah exactly the same.

Audio interface is balanced properly on the outputs?

Is the distance between the ceiling and the speakers the same on both sides?
Have you tried switching the two maybe.

If not a rogue software setting, I'd guess a room problem with reflection, or monitor positioning. Are they brand new/used/refurb?
Try 1/4 TRS cables instead too, the 6.3mm one.

wub wrote:Audio interface is balanced properly on the outputs?

Sorry what?

AxeD wrote:Is the distance between the ceiling and the speakers the same on both sides?
Have you tried switching the two maybe.

Yep & yep. I think it may be the cables actually to be honest.

My left side is unfortunately a foot and a half away from a wall and the right side is about 15, causes all kinds of problems.

Isnt this exactly why they both have individual volume controls?

I had this problem with my KRK 5's but it was solved by turning the gain to +6 on both. What are yours set at? I had problems with the volume dropping out as well when both were set at -6 or 0 but it does say in the manual to set them to +6 for best performance.

I would blow the cones out of my krk's a few hundred yards if I turned mine up to -6db.

Perej wrote:

Huts wrote:this may sound silly but it's gotta be asked, are the individual speakers volumes at the same level?

Yeah exactly the same.

And nothing is panned right or left ?

nowaysj wrote:I would blow the cones out of my krk's a few hundred yards if I turned mine up to -6db.

What? Why would that blow the cones out?

So your saying the cables your using are diferent? or are they a pair?

pair blad

KRK's are shit. My rokit 8's have different volume levels at the same gain setting too. I wish i'd spent more and got a decent pair of monitors. Just turn the gain down on the louder one, that's all i've done.

Well might be your soundcard and or mixer?

Depone wrote:Well might be your soundcard and or mixer?

Hmm. I still don't know too much about this. I have a saffire 6 usb interface, so surely when that is plugged in the soundcard/mixer on my laptop isn't used right?

I'm not even sure if I'm using the right cables tbh they are the same size as TRS but i plug them into an xlr with an adapter. Meh. Maybe they aren't correct.

Thanks for the answers.

Depends if the adapter accepts trs input. Could just accept unbalanced ts 1/4 inch. I'd just get the right cables, it is not worth it trying to figure this shit out. If your soundcard only has balanced trs out, (forget about the krk's, they take xlr, do they take 1/4 balanced, I forget, but if it is 1/4 unbalanced only, just buy a cable that goes 1/4 balanced trs to xlr (of the gender that you need to get into the krk).

VirtualMark wrote:KRK's are shit. My rokit 8's have different volume levels at the same gain setting too. I wish i'd spent more and got a decent pair of monitors. Just turn the gain down on the louder one, that's all i've done.

KRK's are actually very good entry level monitors! There is a reason for it.. they may be defected or they are not connected properly.. but comments like this make no sense at all!