Page 1 of 1
Tip for mastering brostep/edm/loud as fuck music
Posted: Sat May 10, 2014 7:40 pm
by mromgwtf
When mastering, put a multiband peak compressor and compress the highs as shit, up to 7db gain reduction. Use low ratio, I wouldn't go above 2:1. Set the attack to ~20-40ms to let the transients go through. It makes the track feel SOLID.
Re: Tip for mastering brostep/edm/loud as fuck music
Posted: Sat May 10, 2014 7:45 pm
by Banesy
Pffff just sausage fatten it bro. That's how you make it sound ssssssssssssssick
Re: Tip for mastering brostep/edm/loud as fuck music
Posted: Sat May 10, 2014 9:51 pm
by mromgwtf
Banesy wrote:Pffff just sausage fatten it bro. That's how you make it sound ssssssssssssssick
Lol you're obviously unskilled. Pros use soundgoodizer. Skrillex is my friend so I know some shit.
Re: Tip for mastering brostep/edm/loud as fuck music
Posted: Sun May 11, 2014 7:58 am
by xtcvsmistycold
mromgwtf wrote:Lol you're obviously unskilled.
Re: Tip for mastering brostep/edm/loud as fuck music
Posted: Mon May 12, 2014 2:06 pm
by Banesy
mromgwtf wrote:Banesy wrote:Pffff just sausage fatten it bro. That's how you make it sound ssssssssssssssick
Lol you're obviously unskilled. Pros use soundgoodizer. Skrillex is my friend so I know some shit.
I don't know man...SF just adds that je ne sais quoi....
Re: Tip for mastering brostep/edm/loud as fuck music
Posted: Mon May 12, 2014 5:48 pm
by outbound
Amateurs, everyone knows you just bitcrush it till it shows -1db rms on the scale and the analyser says the frequencies are flat...
Re: Tip for mastering brostep/edm/loud as fuck music
Posted: Mon May 12, 2014 6:17 pm
by mthrfnk
On a serious note: check how a limiter/multiband comp is going to affect your mix periodically, for example how they'll affect the transients of your drums, makes a difference if you start smashing the shit of your mix.
Re: Tip for mastering brostep/edm/loud as fuck music
Posted: Tue May 13, 2014 1:23 am
by OfficialDAPT
Worth a shot I suppose.
Re: Tip for mastering brostep/edm/loud as fuck music
Posted: Tue May 20, 2014 8:17 am
by outbound
OfficialDAPT wrote:Worth a shot I suppose.
Listening to a mix and your avatar fitted so well, was a mesmerising experience
Re: Tip for mastering brostep/edm/loud as fuck music
Posted: Tue May 20, 2014 8:29 am
by topmo3
always when i make a tune, i add this effect rack in the master channel with a multiband dynamics, compressor and limiter. makes the tune sound decent. the point is not to make as loud as possible, just as close to a "real" tune as possible, load it up to serato and compare da waveforms.
Re: Tip for mastering brostep/edm/loud as fuck music
Posted: Wed May 21, 2014 1:11 am
by hifi
good tip