Page 1 of 1
@ Massive Heads
Posted: Fri Jul 04, 2008 8:52 pm
by rosco
Hi Guys,
Is there a way to Automate the lfo steps in Massive?
At the moment i'm creating a new channel and instrument everytime I want to change the lfo rate from 1, 2, 4, 8 , 12, 16 etc
Is there a way to automate this on the track?
Thanks
Posted: Fri Jul 04, 2008 9:57 pm
by martello
Posted: Sat Jul 05, 2008 8:59 am
by sleepgolfer
here we go again...
is this the point where all the forum natives start giving advice on having to be original and doing ur own ting?
Posted: Sat Jul 05, 2008 10:22 am
by jblake
You can get two fractions of lfo speed in one instance of massive by doing the following:
Assign Lfo5 to filter 1 cutoff, set that to say, 1/4
Assign Lfo6 to filter 2 cutoff, set that to 1/8
Automate the slider between the two filters to alternate between the different lfo speeds.
Hope this helps.
Posted: Sat Jul 05, 2008 1:14 pm
by rosco
sleepgolfer wrote:here we go again...
is this the point where all the forum natives start giving advice on having to be original and doing ur own ting?
Don't worry I have plenty of originality!! ; ) Too many ideas for my own mind to handle.
Cheers JBlake, will try this out!!!
Rosco
Posted: Wed Jul 09, 2008 1:50 pm
by dem ones
if u dont use the sync option u can automate the lfo rate, jus takes a bit more time to get bang on but u can get some quirky riddims from it
Posted: Tue Jul 15, 2008 9:31 pm
by bscorpio
dem ones wrote:if u dont use the sync option u can automate the lfo rate, jus takes a bit more time to get bang on but u can get some quirky riddims from it
This.
Posted: Wed Jul 16, 2008 12:44 am
by psyolopher
JBlake wrote:You can get two fractions of lfo speed in one instance of massive by doing the following:
Assign Lfo5 to filter 1 cutoff, set that to say, 1/4
Assign Lfo6 to filter 2 cutoff, set that to 1/8
Automate the slider between the two filters to alternate between the different lfo speeds.
Hope this helps.
haha good idea!
why didnt i think of that?
DOOH!